CO2 Laser Not Cutting? 5 Common Causes and Quick Fixes
This troubleshooting guide covers the 5 most common reasons why your CO2 laser cutting machine suddenly loses cutting power, with step-by-step diagnostic procedures and repair solutions you can perform yourself.
4 reviews for S3015 Laser Cutting Machine
Nisha –
Our bakery racks use stainless shelf blanks with rows of slots for air to pass through. The fiber laser cuts the slots and the outside shape in the same run. I check the small bridges of metal between the slots before bending the edges. One lot needed a light cleanup at the corners, which we did at the finish bench. Once the shelves were bent, they slid into the rack we use for checks. Having the cutting file saved helps when the bakery orders just a few replacements.
Matilda –
We use the AccTek Group fiber laser for brass door plates. Several shapes use the same key opening and screw holes. On brushed sheet, I arrange the plates so the lines in the finish all run the same way. That can leave a strip of sheet unused, which I allow for when I plan the order. We smooth the exposed edges after cutting and put a finished plate over the lock to check the fit. The machine works well for the small runs we do.
Edwin –
I build control panels with aluminum faces. We use the fiber laser for the display opening and the holes for the buttons. On one panel, the label had to fit in the space between a switch and the display. I laid the real parts on a cut face before we bent it and saw that the gap needed more room. We shifted the opening on the drawing and saved that version. The useful part for me is being able to check a change on an actual panel.
Clarence –
We make mild steel covers for small machines. On the AccTek Group laser, I cut the vent slots and hinge holes while each blank was flat. One order had left and right covers, so I kept a bent sample of each beside the bench. We checked that both covers cleared the frame when they swung open. On a few blanks, I smoothed a rough corner before sending them for paint. I can bring up either cutting file now when a customer needs a spare cover.