CO2 Laser Not Cutting? 5 Common Causes and Quick Fixes
This troubleshooting guide covers the 5 most common reasons why your CO2 laser cutting machine suddenly loses cutting power, with step-by-step diagnostic procedures and repair solutions you can perform yourself.
4 reviews for P6024-TS Side-Mounted Zero Remnant Tube Laser Cutting Machine
Milo –
Our shop cuts round stainless tube for exhaust sections. On one job, a smaller tube had to meet the main pipe at an angle. The laser cut the branch opening from the drawing, so I could try both pieces together at the bench. I cleaned a rough spot on the inside edge before welding. We left extra length on the ends because the assembly was going into an older vehicle. I like having the branch opening ready and some room left to trim the ends after checking the fit.
Noor –
Most of my work is square tube for exercise benches. I like that the laser cuts the legs to length and adds the holes for the feet in the same job. We use two lengths that share the same hole spacing, so I keep a sample of each at the assembly bench. There was a bit of cleanup inside one tube where a bolt needed to pass through. I check that spot on repeat orders. Getting the legs ready in sets helps us keep the bench frames moving.
Cindy –
We cut rectangular tubing for steel table frames. On the AccTek Group machine, I cut the ends and the slots for the crossbar tabs from the same drawing. The customer asked us to move the crossbar back to make room for chairs. I updated the file and tried a pair of side pieces in our frame before cutting the rest. We checked the fit at the welding bench with the legs in place. That revised file is ready if the customer wants another set for the same room.
Maureen –
We use the AccTek Group tube laser for round stainless posts. The cut at the top has to sit against the handrail, and on stairs the angle changes from job to job. I lay the first cut post against a sample rail before we run the set. On one order, two posts were close in length, so I asked the crew to tag them by stair position. We had every post ready in order at the welding bench, which made that job easier to put together.